Switching The Remote Control Id - Yamaha R-S700 Owner's Manual

Switching the remote control ID

When using multiple Yamaha receivers or amplifiers with
the same default code setting, you may unintentionally
operate those components simultaneously. In this case, set
one of the alternative codes for this unit to operate this
unit separately.
ID
• Switching to ID1
Press and hold the ID button and the numeric button
"1" on the remote control together for about 3 seconds.
• Switching to ID2
Press and hold the ID button and the numeric button
"2" on the remote control together for about 3 seconds.
Remote control ID*
(this unit's setting)
ID1
ID2
(default setting)
* When you change the remote control ID, you must
change the remote control ID of this unit (see page 34).
Note
If the remote control batteries are weak or removed, the remote
control ID will switch to the default setting (ID2). In this case,
replace the batteries and set the remote control ID again.
1
2
Function
To operate this unit using
an alternative code.
To operate this unit using
the default code.
ADVANCED SETUP
35
En