Introduction; Front View - ATEN Master View CS-88A User Manual

Introduction

Front View

1. Port Selection Switches
Press a switch to access the computer attached to the corresponding port.
M
Pressing Buttons 1 and 2 simultaneously for 3 seconds performs a
Keyboard and Mouse Reset.
M
Pressing 7 and 8 simultaneously starts Auto Scan Mode (see p. 30).
2. Port LEDs
The Port LEDs are built into the Port Selection Switches. The upper ones are
the On Line LEDs; the lower ones are the Selected Port LEDs:
M
The On Line LEDs light ORANGE to indicate that the computer attached
to the corresponding port is up and running. If the LED is flashing, it
indicates that the Port is being used for cascading to another Master View
switch (see Two Stage Installation, p. 8).
M
The Selected LEDs light GREEN to indicate that the computer attached to
the corresponding port is the one that has the KVM focus. The LED is
steady under normal conditions, but flashes when its port is accessed
under Auto Scan Mode (see F7 SCAN, p. 30).
3. Reset
Use a thin object (such as the end of a paper clip, or a ballpoint pen), to
press this recessed switch in to initiate a warm reset. If the switch is kept in
for longer than three seconds, a cold reset takes place.
4. Power LED
Lights to indicate that the unit is receiving power.
CS-88A User Manual
1&2
2002-12-27
3 4
5