Table of Contents
Advertisement
Accessories
Rôtisserie Accessories
Drip tray
For use in "Rôtisserie" mode, this glass dish is placed in the cen-
tre of the turntable to catch the cooking juice from meat and
poultry.
The main spit is fitted in the centre of the dish.
Main spit
This spit is used for cooking poultry and roasts in "Rôtisserie"
mode.
Using this accessory saves the need to turn meat and poultry
during cooking. They will be nicely crisp and brown all over.
Skewer holder
This is fitted onto the main spit. It has 6 notches to take the ske-
wers.
6 skewers
These can be used for cooking kebabs of meat, poultry, fish,
vegetables and/or fruit.
They are fitted on the skewer holder.
Installation
Preparation
Unpack the accessories, wash them and wipe them off carefully.
Position the ring bearing and then the turntable in the centre of the oven.
The turntable must be properly engaged with the drive.
Connecting
Check that the supply voltage marked on the type label glued on the rear
of the appliance matches the voltage of your supply. The label indicates
the nominal supply voltage of the appliance, e.g. 220-230 V.
Ensure that the current marked on your electricity meter and circuit brea-
ker / fuse is at least 16 Amperes.
Finally, for proper safety, it is essential to connect your appliance to an
outlet socket with an earth connection in accordance with electrical instal-
lation regulations and standards.
Position the appliance in such a way that the supply socket is readily acces-
sible so that it can be easily disconnected.
You should also ensure that you can gain access to your circuit breaker /
fuse.
It is imperative to comply with the above instructions regarding the
electrical supply.
Position
Your appliance can be installed in one of two ways :
•On a worktop : position the appliance on a flat and stable surface,
capable of supporting the oven and its contents. The oven must be
handled with care, remembering that the control panel side is the
heavier.
•In a niche : The niche must be at least 85 cm above floor-level. Centre
the appliance in the niche so that it does not touch the sidewalls.
Adequate ventilation is essential: the minimum clearances are 20 cm
above the oven and 10 cm at the sides and rear.
Install the appliance away from any source of heat such as a traditional oven
or radiator. It has been designed and tested for use in ambient temperatures
up to 35°C.
Ensure that the ventilation holes of the appliance are not obstructed.
27
GB
Hide quick links:
Advertisement
Table of Contents
