Motorola RDU2080d User Manual page 61

6. Place the "Source Radio" in its SUC, press and
release Side Button 1 (SB1).
7. After cloning is completed, the "Source Radio"
will sound either a "pass" tone (cloning was
successful) or a "fail" tone (cloning process has
failed). The pass tone sounds like a good key
"chirp" whereas the "fail" tone sounds similar to
a "bonk" tone. If the "Source Radio" is a radio
with a display, it will either show "Pass" or "Fail"
on the display. (A tone will be heard in no more
than 5 seconds).
8. Once you have completed the cloning process,
you should turn the radios "OFF" and "ON" to
bring them to normal user mode (exit "clone"
mode).
What to do if cloning fails
The radio will emit an audible "bonk" indicating
that the cloning process has failed. In the event
that cloning fails, try performing each of the
following before trying to start the cloning
process again.
1. Make sure that the radio batteries on both
radios are fully charged.
2. Verify the cloning cable connection on both
SUCs.
3. Make sure that the battery is engaged properly
on to the radio.
4. Make sure that there is no debris in the
charging tray or on the radio contacts.
5. Verify that the source radio is in cloning mode.
6. Make sure that the radio to be cloned is turned
ON.
7. Make sure that radios are both from the same
type (same frequency band, same front panel
(display/non display), same region and same
transmission power).
Note: This cloning cable is designed to operate
only with compatible Motorola RLN6175
(Standard) and RLN6304 (Rapid) Single
Unit Chargers.
When ordering Cloning Cable please refer to P/
N RLN6303. For details about accessories
refer to Accessories section.
59
English