Simple Serial Interface Default Parameters - Symbol DS6707 Product Reference Manual

Simple Serial Interface Default Parameters

Table 6-1 lists the defaults for the SSI host. There are two ways to change the default values:
•
Scan the appropriate bar codes in this guide. These new values replace the standard default values in
memory. To recall the default parameter values, scan the
•
Download data through the device's serial port using SSI. Hexadecimal parameter numbers appear in this
chapter below the parameter title, and options appear in parenthesis beneath the accompanying bar codes.
See the Simple Serial Interface (SSI) Programmer's Guide for detailed instructions for changing parameters
using this method.
NOTE See
miscellaneous default parameters.
SSI Interface Parameter Defaults
Table 6-1
Parameter
Baud Rate
Parity
Check Parity
Software Handshaking
Host RTS Line State
Decode Data Packet Format
Stop Bits
Host Serial Response Time-out
Host Character Time-out
Multipacket Option
Interpacket Delay
Event Reporting
Decode Event
Boot Up Event
Parameter Event
NOTE SSI interprets Prefix, Suffix1, and Suffix2 values listed in
interfaces. SSI does not recognize key categories, only the 3-digit decimal value. The default value of
7013 is interpreted as CR only.
Appendix A, Standard Default Parameters
Parameter
Number
9Ch
9Eh
97h
9Fh
9Ah
EEh
9Dh
9Bh
EFh
F0h 4Eh
F0h 4Fh
F0h 00h
F0h 02h
F0h 03h
Set Default Parameter on page
for all user preferences, hosts, symbologies, and
Default
9600
None
Enable
ACK/NAK
Low
Send Raw Decode Data
1
2 sec
200 msec
Option 1
0 ms
Disable
Disable
Disable
Table A-1 on page A-1
SSI Interface
4-4.
Page
Number
6-4
6-6
6-7
6-7
6-8
6-8
6-9
6-10
6-11
6-12
6-13
6-14
6-15
6-15
differently than other
6 - 3