Chapter 5 Imaging Preferences; Introduction - Symbol DS6707 Product Reference Manual

Chapter 5 Imaging Preferences

Introduction

You can program the digital imager scanner to perform various functions, or activate different features. This
chapter describes imaging preference features and provides programming bar codes for selecting these features.
The digital imager scanner ships with the settings in
see Appendix A, Standard Default Parameters
suit requirements, programming is not necessary.
To set feature values, scan a single bar code or a short bar code sequence. The settings are stored in non-volatile
memory and are preserved even when you power down the digital imager scanner.
NOTE Most computer monitors allow scanning the bar codes directly on the screen. When scanning from the
screen, be sure to set the document magnification to a level where you can see the bar code clearly, and
bars and/or spaces are not merging.
If not using a USB cable, select a host type after the power-up beeps sound. See
7, USB Interface and
first power-up when connecting to a new host.
To return all features to default values, scan the
bar code menus, asterisks (
*
Chapter 8, RS-232 Interface
*
) indicate default values.
*
Enable Decode Aiming Pattern
Indicates Default
Imaging Preferences Parameter Defaults on page 5-2
for all host device and miscellaneous defaults). If the default values
for specific host information. This is only necessary upon the
Set Default Parameter on page
(02h)
Chapter 6, SSI Interface,
4-4. Throughout the programming
Feature/Option
Option Hex Value
for programming
via SSI command
(also
Chapter