Decode Session Timeout; Timeout Between Decodes, Same Symbol - Symbol DS6707 Product Reference Manual

4 - 10 Symbol DS6707 Digital Imager Scanner Product Reference Guide

Decode Session Timeout

Parameter # 88h
This parameter sets the maximum time decode processing continues during a scan attempt. It is programmable in
0.1 second increments from 0.5 to 9.9 seconds. The default timeout is 9.9 seconds.
To set a Decode Session Timeout, scan the bar code below. Next, scan two numeric bar codes from
Numeric Bar Codes
example, to set a Decode Session Timeout of 0.5 seconds, scan the bar code below, then scan the 0 and 5 bar
codes. To correct an error or change the selection, scan Cancel on
Decode Session Timeout

Timeout Between Decodes, Same Symbol

Parameter # 89h
Use this option in presentation (hands-free) mode to prevent the beeper from continuously beeping when a symbol
is left in the digital imager scanner's field of view. It is programmable in 0.1 second increments from 0.0 to 9.9
seconds. The default interval is 0.6 seconds.
To select the timeout between decodes for the same symbol, scan the bar code below, then scan two numeric bar
codes from Appendix D, Numeric Bar Codes
that correspond to the desired on time. Enter a leading zero for single digit numbers. For
that correspond to the desired interval, in 0.1 second increments.
page D-2.
Timeout Between Decodes, Same Symbol
Appendix D,