Upc/Ean/Jan Supplemental Redundancy; Transmit Upc-A Check Digit - Symbol DS6707 Product Reference Manual

10 - 14 Symbol DS6707 Digital Imager Scanner Product Reference Guide

UPC/EAN/JAN Supplemental Redundancy

Parameter # 50h
If you selected Autodiscriminate UPC/EAN/JAN Supplementals, this option adjusts the number of times a
symbol without supplementals is decoded before transmission. The range is from two to thirty times. Five or above
is recommended when decoding a mix of UPC/EAN/JAN symbols with and without supplementals. The default is
set at 10.
Scan the bar code below to set a decode redundancy value. Next, scan two numeric bar codes in
Numeric Bar Codes. Enter a leading zero for single digit numbers. To correct an error or change a selection, scan
Cancel on page D-2.
UPC/EAN/JAN Supplemental Redundancy

Transmit UPC-A Check Digit

Parameter # 28h
The check digit is the last character of the symbol used to verify the integrity of the data. Scan the appropriate bar
code below to transmit the bar code data with or without the UPC-A check digit. It is always verified to guarantee
the integrity of the data.
*
Transmit UPC-A Check Digit
(01h)
Do Not Transmit UPC-A Check Digit
(00h)
Appendix D,