Errors While Scanning; Symbology Parameter Defaults - Symbol DS6707 Product Reference Manual

10 - 2 Symbol DS6707 Digital Imager Scanner Product Reference Guide

Errors While Scanning

Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.

Symbology Parameter Defaults

Table 10-1 lists the defaults for all symbologies parameters. There are two ways to change the default values:
•
Scan the appropriate bar codes in this guide. These new values replace the standard default values in
memory. To recall the default parameter values, scan the
•
Download data through the device's serial port using SSI. Hexadecimal parameter numbers appear in this
chapter below the parameter title, and options appear in parenthesis beneath the accompanying bar codes.
See the Simple Serial Interface (SSI) Programmer's Guide for detailed instructions for changing parameters
using this method.
NOTE See
parameters.
Parameter Defaults
Table 10-1
Parameter
UPC/EAN
UPC-A
UPC-E
UPC-E1
EAN-8/JAN 8
EAN-13/JAN 13
Bookland EAN
Decode UPC/EAN/JAN Supplementals
(2 and 5 digits)
User-Programmable Supplementals
Supplemental 1:
Supplemental 2:
UPC/EAN/JAN Supplemental Redundancy
Transmit UPC-A Check Digit
Transmit UPC-E Check Digit
Transmit UPC-E1 Check Digit
UPC-A Preamble
UPC-E Preamble
Appendix A, Standard Default Parameters
Set Default Parameter on page
for all user preferences, hosts, and miscellaneous default
Parameter
Default
Number
01h Enable
02h Enable
0Ch Disable
04h Enable
03h Enable
53h Disable
10h Ignore
F1h 43h
F1h 44h
50h 10
28h Enable
29h Enable
2Ah Enable
22h System Character
23h System Character
4-4.
Page
Number
10-7
10-7
10-8
10-8
10-9
10-9
10-10
10-13
10-14
10-14
10-14
10-15
10-16
10-16