Wall Mounting Template - Motorola SURFBOARD SVG2500 User Manual

2 INSTALLATION
Caution!
Use M3.5 x 38 mm (#6 x 1
screw head diameter of 7 .0 mm to mount the SVG2500.
8. Using a screwdriver, turn each screw until part of it protrudes from the wall, as
shown in the following illustration.
There must be .09 inches (2.3 mm) between the wall and the underside of the
screw head.
9. Place the SVG2500 so the keyholes on the back of the unit are aligned above the
mounting screws. Be sure you do not damage the antennas.
10. Slide the SVG2500 down until it stops against the top of the keyhole opening.

Wall Mounting Template

You can print this page to use as a wall mounting template.
Be sure you print it at 100% scale. In Acrobat Reader, be sure that Fit To Page is not
selected in the Print dialog box.
Measure the printed template with a ruler to ensure that it is the correct size.
Before drilling holes, check the structure for potential damage to water, gas, or electric
lines.
If necessary, seat an anchor in each hole.
1
/ inch) screws with a flat underside and maximum
2
55