Motorola SURFboard DOCSIS SB6120 User Manual page 19

2 INSTALLATION
The sample Print dialogue window shown below may vary slightly on your
computer, depending upon your operating system.
To print the template only, select Current page as the Print Range. Be sure you
print the template at 100% scale. Be sure No Scaling is selected for Scale to
paper size.
3. Click OK to print the template.
4. Measure the printed template with a ruler to ensure that it is the correct size.
5. Use a center punch to mark the center of the holes.
6. On the wall, locate the marks for the mounting holes.
7. Drill the holes to a depth of at least 1 1/2 inches (3.8 cm). Use M3.5 x 38 mm (#6
x 11/2 inch) screws with a flat underside and maximum screw head diameter of
9.0 mm to mount the SB6120.
8. Using a screwdriver, turn each screw until part of it protrudes from the wall, as
shown in the following illustration.
There must be .10 inches (2.5 mm) between the wall and the underside of the
screw head.
9. Place the SB6120 so the keyholes on the back of the unit are aligned above the
mounting screws.
6.0 mm (.24 inches) maximum
9.0 mm (.35 inches) maximum
2.5 mm (.10 inches).
11