Guidelines For Installation And Connection - Motorola T605 Motomanual

Universal bluetooth in-car music & hands-free system
Hide thumbs Also See for T605:
Table of Contents

Advertisement

Guidelines for Installation and Connection

• Only qualified personnel should install this car kit. Because of the wide variety of vehicle types and models it
may be necessary to contact the vehicle manufacturer for detailed installation information. If needed, contact
the vehicle manufacturer for air bag information specific to the vehicle.
Caution: An air bag inflates with great force. DO NOT place objects, including communication equipment, in the
area over the air bag or in the air bag deployment area. If the communication equipment is improperly installed
and the air bag inflates, serious injury could occur.
• Mount components securely on strong surfaces to prevent shifting that could cause injury or interfere with safe
vehicle operation. Always use the supplied mounting hardware.
• Mounted components and attached wires or cables must not interfere with seating or leg space.
• Route cables so they are protected from pinching, sharp edges and crushing. Keep all in-line connectors easily
accessible.
• The car kit is intended for use in 12 Volt negative ground systems only. The car kit draws less than 3 Amps.
Confirm that the vehicle's electrical system can supply this current.
• The installation steps are in no particular order. In general, you should first pick the locations where you will
be mounting the UIM, microphone, speaker, and ECU. Mount the UIM, speaker and microphone and route the
cables to the ECU mounting location. Install the power adaptor cable. Plug everything into the ECU, and then
mount the ECU.
The car kit has separate output paths for the handsfree audio (line and speaker levels) and music (RCA line-level
output). Both handsfree and music audio paths need to be connected for full system operation.
Installing the Handsfree Car Kit
Caution: This car kit must be connected to a maximum 5 Amp fuse in the car fuse panel to prevent fire or other
damages should a short circuit occur in the ECU.
Before installation, unpack, assemble, and test all components on a service bench.
Installing the Electronic Control Module (ECU)
Mount the ECU securely.
The best location for the ECU is under the dash. The box must be protected from dirt and moisture, have adequate
space for cooling, and allow for cable connections.
For optimal Bluetooth performance, mount the ECU so that the side with the barcode faces away from the mounting
surface. The ECU can be oriented in any direction. Do not place it behind or within large areas of metal.
Caution: The location must not interfere with the vehicle's air bag.
Barcode
Mounting Surface
Mounting Surface
Barcode
English
3

Advertisement

Table of Contents
loading

This manual is also suitable for:

T600

Table of Contents