Summary of Contents for Morphy Richards Turbo steam iron
Page 1
Always switch off the unit and allow to cool before cleaning or storing. • Jet cleaning Your iron will give the best ironing results and will last longer if you apply jet cleaning after each period of ironing. www.morphyrichards.co.uk...
To avoid the risk of electric shock, do not disassemble the iron, but telephone Morphy Richards for advice. Incorrect reassembly can cause a risk of electric shock when the iron is used.
Instructions for use Temperature guide Heat setting markings on the adjustable control dial of all Morphy Richards irons match those of the International Textile Care Labelling Code. Symbol Do not...
If you wait a few minutes, the iron will stabilise at the required setting. Your Morphy Richards iron is fitted with an indicator light ‡ which will go on and off while you are ironing.
Dry ironing You can use your iron as a dry iron only. Make sure the variable steam control ‹ is set to the ‘0’ symbol. Any temperature setting may be used depending on the garment.
The ‘jet clean’ should be operated after each period of ironing. To operate, ensure that there is little water in the tank, place the iron on its heel and turn the temperature control dial to the maximum setting. Wait for the temperature indicator light to go out, then unplug the iron and hold it about 6’’...
Page 7
To clean a coated soleplate (certain models only) In the unlikely event of any man-made fibre fusing to the soleplate, set the iron at the 3 dot position and pass it over a clean piece of cotton which will draw the deposit off the surface.
Page 8
24 months of original purchase, you should contact the Helpline number quoting Model number and Serial number on the product, or write to Morphy Richards at the address shown. You will be asked to return the product (in secure, adequate packaging) to the address below along with a copy of proof of purchase.
This manual is also suitable for:
Ib40655Ib40660Ib40665Turbosteam 40666Turbosteam 40665Turbosteam 40675...
Show all