Monster Power PRO 7000 Owner's Manual page 37

Professional reference powersource with dual balanced pure power
Table of Contents

Advertisement

LIT_PRO7000_manual.qxd
11/10/2003
4:30 PM
Page 31
Q. Will it damage a component if plugged into a PowerSource outlet that's not designed
for it, like putting a high-power amplifier into a Mixer/Preamplifier outlet?
A. No. However, as mentioned, you may not realize the full performance potential of the component.
Q. If my PowerSource stops operating, what should I do?
A. First check the reset button labeled BREAKER 15A on the rear panel of the PowerSource. It's possible
an overload condition can be caused by high-powered audio equipment. If your amplifiers draw too much power,
a special circuit breaker may be tripped. To restore operation, wait 10 minutes and press the reset button.
If power is still not restored, refer to page 24 and read through the related troubleshooting questions.
30

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents