Glass Removal; Log Placement; Rockwool Placement - Monessen Hearth CDV7 Installation And Operating Instructions Manual

CDVSC7 & CDV7 Series Gas Fireplace
GlaSS FRaMe ReMoVal
1. Remove upper and lower louvers.
. Release the clamps on the bottom of the fireplace.
Figure 61
3. Tilt glass frame out and lift glass frame up until it clears
the hook on top of the frame.
4. Set glass frame aside.
each clamp has a quick spring force. when
reinstalling clamps, keep fingers clear.
WARNING
!
RoCK wool plaCeMenT
1. For best results in flame appearance and opera-
tion, use one (1) 8 gram bag of rock wool for
propane/LP models and up to three (3) bags of
rock wool for natural gas models.
. Pull the rock wool apart into dime-sized pieces
or smaller. Cover the entire surface of the burner
with one thin layer of rock wool.
3. Place the logs on the burner. Refer to the "Log
Placement Section". Light the unit and after 15
minutes check burner flame and glow. Adjust
embers as necessary to achieve an even and
clean flame.
46
Glass Frame
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
GlaSS ReMoVal & RoCK wool plaCeMenT
Clamps -
 on 33/36 Models,
3 on 4/47 Models
Figure 61 -
Removing Glass Frame - CDVR Series Shown
FP2297
remove glass
Cover with
Rock Wool
Figure 62 - Placement of Rock
FP2648
Wool on Burner
BDV rock wool place
The use of too much rock wool could
cause flame to burn poorly and may cause
sooting.
Burner
FP97
FP648
69D3011