Philips HX6942/14 Service Manual

Philips Consumer Lifestyle
Service Manual
PRODUCT INFORMATION
Sanitizing
With the UV sanitizer you can clean your brush head after every
use. After brushing, rinse the brush head and shake off excess
water. Place your finger in the door recess on top of the
sanitizer and pull open the door. Place the brush head on one of
the two pegs in the sanitizer so that the bristles are directly
facing the light bulb. Close the door and press the green power
on/off button once to start the UV clean cycle. It runs for 10
minutes then automatically shuts off. The sanitizer is in
operation when the blue light glows through the window and the
UV clean LED flashes slowly.
Note: The sanitizer stops if the door is opened during operation.
Easy-start
This Sonicare model comes with the Easy-start feature activated.
The Easy-start feature gently increases power over the first 14
brushings to ease into the Sonicare experience..
Easy-start can also be switched off.
To deactivate Easy-start:
Press and hold the power on/off button for 2 seconds. You hear
1 beep to indicate that the Easy-start feature has been
deactivated.
To activate Easy-start:
Press and hold the power on/off button for 2 seconds. You hear
2 beeps to indicate that the Easy-start feature has been activated.
Smartimer
The Smartimer indicates that your brushing cycle is complete
when it automatically turns off the toothbrush at the end of the
brushing cycle. Dental professionals recommend brushing at
least 2 minutes twice a day.
Published by Philips Consumer Lifestyle
6/2009
Quadpacer
The Quadpacer feature ensures that you brush all four sections
of your mouth evenly and thoroughly. You will hear a short
beep and notice a brief pause in brushing action. This is the
signal to move to the next section of your mouth. The
Quadpacer feature on this model has been activated. To
deactivate or reactivate the Quadpacer features:
Place the handle with a brush head attached on the plugged-in
charger.
Press and hold the mode button for 2 seconds.
You hear 1 beep to indicate the Quadpacer has been deactivated
or you hear 2 beeps to indicate the Quadpacer has been
activated.
Brushing modes
The programmable brushing allow you to customize the
brushing action. There are five different brushing modes.
Clean: Complete whole mouth cleaning (2 minutes).
Gum Care: Complete whole mouth cleaning (2 minutes) plus
gentle cleaning for problem areas and along the gumline (1
minute).
Refresh: Touch-up for a quick clean (1 minute).
Sensitive: Gentle cleaning for sensitive gums and teeth (2
minutes).
Massage: Gentle gum stimulation (2 minutes).
Battery gauge
When the handle is placed in the charger, the flashing light of the
battery gauge indicates that the toothbrush is charging.
Indicates amount of charge left in battery
3 green LEDs: fully charged
2 green LEDs: 67-94%
1 green LED: 34-66%
Printed in the Netherlands © Copyright Reserved
Sonic toothbrush
HX6942/14, HX6942/20,
HX6962, HX6972, HX6992
Subject to modification