Moen 2200 Series Installation Instructions

MODELS 2200, 2400 & 72200 SERIES
TUB AND SHOWER VALVES
All models have 4 port castings. Stops are optional on all models. All models are also available for 1/2 inch I.P.S. pipes
or 1/2 inch copper sweat connections to copper water tubing. The 2400 series include built in pushbutton diverter.
Measurements
These are shown in the drawings. The depth
measurement is critical. Use the front face of
the plaster ground as a reference point for the
finished wall position, including tile (2-1/16"
[51mm]). The center line of the supply and
discharge piping should be a maximum of 2-3/16"
(56mm) and a minimum of 1-7/16" (37mm) behind
the finished wall surface.
HANDLE
UP
UP
CAUTION:
Before turning water on during either rough-in or trim-out, make sure that cartridge retainer clip is in place. The
cartridge and retainer clip were properly installed and tested before leaving the factory. Although it is unlikely, it is
nevertheless possible that through the handling of the valve by any number of persons the retainer clip may not be
properly installed. This should be carefully checked at time of rough-in and trim-out. If the retainer clip is not properly
installed, water pressure could force the cartridge out of the casting. Personal injury or water damage to the
premises could result.
®
HANDLE
KNOB
O-RING
ESCUTCHEON
COVER
HANDLE
WASHER
SCREW
2400 MODEL SERIES
PUSH BUTTON DIVERTER
MODEL ILLUSTRATED
Always turn water off before disassembling the valve. Open valve handle to
alleviate water pressure to insure that complete water shut-off has been
accomplished.

INSTALLATION INSTRUCTIONS

THESE INSTRUCTIONS MUST BE
WALL LINE
2-1/16"
(52mm)
PLASTER
GROUND
UP
FLOOR
LEFT WITH HOMEOWNER
ALL DIMENSIONS NOMINAL
IMPORTANT: SEE FLUSHING
INSTRUCTIONS PAGE 2
1-1/4"
(32mm)
SUPPLY 1/2" I.P.S. OR
COPPER SWEAT
COMBINATION
MODELS 32"
(813mm)
CAUTION:
USE 1/2" IRON
PIPE SIZE
MINIMUM. DO
NOT USE 1/2"
TUBING, EXCEPT
WHEN SLIP FIT
SPOUT IS USED.
CLIP
EAR
MT659C
6'6"
(1981mm)
SHOWER
45"
(1143mm)
48"
(1219mm)