Table of Contents
Advertisement
Appendix E: Troubleshooting, continued
NetCommand
Symptom
1.
Cannot see the A/V Receiver menu.
2.
NetCommand unable to learn specific device
keys.
3.
The A/V Receiver is the selected audio
source but there is no sound.
TV Guide On Screen
(see the separate TV Guide On Screen® Interactive Program Guide User's Manual for detailed information)
Symptom
1.
TV Guide On Screen® system shows no
program listings.
2.
TV Guide On Screen system program list-
ings don't match actual programs
3.
TV Guide On Screen system does not
change channels on the cable box.
Remarks
The A/V Receiver is not connected to any video input of the TV.
To check the A/V Receiver menu, temporarily plug into an unused
input of the TV, such as Input 3. Exit the Auto Input Sensing screen
and select Input 3 from the Input Selection menu. Press MENU.
•
Device does not use IR format for remote control signal. ITT
and RF formats cannot be learned.
•
Room lighting may affect the signal. Have the remotes very
close (6 inches or less) to the TV during Learning.
•
If learning a Mitsubishi remote control, make sure slide switch
is not set to TV position.
•
Some, but not all, device key functions can be learned by
NetCommand. For example, POWER and PLAY may be
learned, but other functions may not.
•
The signal from the remote control may not be strong
enough. Insert fresh batteries and try Learning again.
Check to see if the A/V Receiver power is turned on. After the
power is turned on, redisplay the Input Selection menu and press
ENTER to allow NetCommand to correctly select the A/V Receiver
input.
Remarks
•
Program listings are downloaded while the TV is off and the
cable box is left on. It may take up to 24 hours to begin to
receive TV program listings. It may take up to one week to
receive all eight days of TV program listings.
•
Invalid ZIP code was entered at the initial TV Guide On Screen
system setup. Select NetCommand from the main TV menu,
then Guide and enter the correct ZIP code.
•
Check the connections between the TV and the TV Guide On
Screen input (cable, antenna or cable box and IR cable). At
least one antenna connection must be associated with the TV
Guide On Screen system to receive program listings.
•
When using CableCARD™, the cable company may have
converted the TV Guide On Screen host channel to a digital
format and lost the information. Connect an antenna to
ANT 2 and memorize the antenna channels in the TV Setup
menu. Add ANT 2 to the TV Guide On Screen setup in the
NetCommand menu. You may be able to download from the
antenna information for both cable and antenna.
•
Incorrect ZIP code was entered at initial TV Guide system
setup. Select NetCommand menu, then Guide to enter the
correct ZIP code.
•
For cable programs, there may be more than one cable
company in your ZIP code. Refer to the TV Guide On Screen
system manual for instructions on the Setup Service.
•
Cable box is not set up in NetCommand. The TV Guide On
Screen system uses NetCommand to control the cable box
and VCR. To correct, select the cable box in the Input Selec-
tion menu, open the NetCommand menu, and select Learn.
See chapter 3, "TV Setup."
•
NetCommand IR emitter is not in place or properly positioned
in front of the cable box remote sensor.
Appendices
Appendices
117
117
Hide quick links:
Advertisement
Table of Contents
