Operation; Mixing The Fuel; Filling The Tank - Toro 51930 Operator's Manual

Operation

Mixing the Fuel

DANGER:
Gasoline is extremely flammable and explosive. A
fire or explosion from gasoline will burn you and
others.
This product is powered by a 2-cycle engine and requires
pre-mixing gasoline and 2-cycle oil. The oil mix should
be 50:1, using oil that meets or exceeds JASO-FC specifi-
cations.
Follow these steps to mix the fuel.
Obtain a clean container that is approved for use
1.
with gasoline.
Mix the 2-cycle engine oil provided with unleaded
2.
gasoline in the container, according to the instruc-
tions on the oil carton.
Important: This engine is certified to operate on
unleaded gasoline intended for automotive use with an
octane rating of 87 ([R + M] / 2) or higher. Do not use
automotive oil or 2-cycle outboard oil. Store the con-
tainer out of the reach of children.
50:1 Gasoline to Oil Mixing Chart
Gasoline Oil
1/2 US gallon 1.3 oz.
1 US gallon 2.6 oz.
2 US gallons 5.2 oz.
1 liter 20 ml
2 liters 40 ml
3 liters 60 ml
4 liters 80 ml
5 liters 100 ml
+ =
16

Filling the Tank

WARNING:
Always stop the engine before filling the tank.
Never add fuel to a machine with a running or hot
engine. Move at least 30 ft. (9 m) away from the
refueling site before starting the engine. Do not
smoke while filling the tank.
Follow these steps to fill the tank.
Clean the surface around the fuel cap to prevent con-
1.
tamination.
Loosen the fuel cap by turning it counterclockwise.
2.
Pour the fuel mixture carefully into the tank.
3.
Clean and inspect the gasket.
4.
Note: Replace the fuel cap if the gasket is damaged.
Install the fuel cap and tighten it by turning it clock-
5.
wise.
WARNING:
Check for fuel leaks. If you find any leaks, correct
the problem before using the product.
Wipe spilled fuel from the product.
6.
Move at least 30 ft. (9 m) away before starting the
7.
product.
Note: It is normal for the engine to emit smoke dur-
ing use.
Operation