Miller Electric MCS-13H Specification Sheet

Miller Sturdi-Saw 1 and Mini 1
Sturdi-Saw 1
B oth the Series 1 and Mini 1 saws share a
number of design features that make
them the most durable and easily main-
tained push saws available. The quick release
blade collars make it easy to install and remove
the blades, eliminating arbor damage caused by
not adequately tightening the arbor nut.
With the engine mounted forward on the
frame, the weight is concentrated over the
arbor. This helps keep the blade in the cut,
thereby increasing cutting speeds.
The tough welded box design reduces
vibration and provides the most stable sawing
platform in the industry. This boxed design is
a Miller original and eliminates the "frame
twist" that is common in saws of lighter con-
struction. This construction minimizes blade
bounce resulting in longer blade life and
improved cutting performance.
Sturdi-Saw Specifications
Mini
Blade capacity 12"-14"
Blade Guard One piece Hinged
Engine
8-13
HP
Sheaves
3 groove (2 groove
for 8 Mini only)
HP
Bushings Quick Disconnect
bushing
Saw 1
Arbor
12"-18"
Arbor belts
13-15
HP
Blade collar
Front wheels 4" x 2"
Rear wheels
(8 thru 15
HP

Standard Features

o Welded box frame construction
o Quick release 1
ing pillow block ball bearings
o Complete console with operating instructions,
stop switch and engine throttle
o Adjustable engine motor mount
o Console mounted, low resistance manual
crank lift with locking mechanism
o Quick disconnect sheaves
The quick disconnect bushings used on
the arbor shaft and motor output shaft allow
the sheaves to be easily removed, even after
years of service. The laminar flow water sys-
tem optimizes water flow on the blade. This
improved water system reduces spray while
delivering more water where the blade meets
the surface.
Mini Saw 1
Mini Saw 1
" with Quick
Rear axle
1 1 ⁄
4
Disconnect collar
Front axle
(3) cog type V belts Length
(2 for 8 Mini only)
Width
" dia.
3 1 ⁄ 4" dia.
Height
2
Quick Release
Depth of Cut
12" Blade
4" x 2"
14" Blade
6" x 2" 8" x 2" 16" Blade
18" Blade
–8–
push saws)
HP
" arbor shaft with self-align-
1 ⁄
4
Mini
"
5 ⁄
8
"
3 ⁄
4
36"
21"
36"
4"
5"
NA
NA
Saw 1
"
3 ⁄
4
"
3 ⁄
4
42"
24"
37"
3.75"
4.75"
5.75"
6.75"