Extending Cooldown Time - Miele NOVOTRONIC T 7634 Operating Instructions Manual

Programmable functions

Extending cooldown time

You can individually lengthen the
cooldown phase the occurs before
the end of a program. Fabrics will be
more completely cooled down.
Cooldown time
– can be extended by two stages.
– it does not function for Smoothing
programme.
For programming and saving in
memory, follow steps
The programmable function is
programmed using the buttons.
Precondition:
– The dryer is switched off.
– The door is closed.
Press Start/Stop and keep it pressed
it during steps
Press the I-On/0-Off button in.
Wait until the Start/Stop button lights up
continuously . . .
. . . then release the Start/Stop
button.
Press the Gentle button three times.
– The Gentle indicator light flashes
briefly seven times.
– P and 0 flash alternatingly in the
display (default setting).
48
to .
- .
The number appearing alternatingly
with P means:
0 Default setting
I Five minutes longer cooldown time
(Express indicator light will flash
once)
2 Ten minutes longer cooldown time
(Express indicator light will also flash
twice)
Pressing the Start/Stop button
switches from one to the other.
Using the I-On/0-Off button, switch
the dryer off.
The programming is now stored in
memory. You can change it again at
any time.