Advertisement
Quick Links
FINAL WIRING CONNECTIONS
Make wiring connections using the EIA color code chart shown below and the
instructions included with the head unit. Metra recommends making connections
as shown below; Strip, Splice, Solder, Tape. Isolate and individually tape off ends
of any unused wires to prevent electrical short circuit.
METRA / EIA WIRING CODE
12V Ignition / Acc. . . . . . . . . . Red
12V Batt / Memory. . . . . . . . . Yellow
Ground. . . . . . . . . . . . . . . . . . Black*
Power Antenna. . . . . . . . . . . . Blue
STRIP
Amp Turn-On . . . . . . . . . . . . . Blue / White
Amp Ground. . . . . . . . . . . . . . Black / White
SPLICE
Illumination . . . . . . . . . . . . . . Orange
Dimmer . . . . . . . . . . . . . . . . . Orange / White
SOLDER
Right Front (+) . . . . . . . . . . . . Gray
Right Front (-). . . . . . . . . . . . . Gray / Black
TAPE
Left Front (+) . . . . . . . . . . . . . White
Left Front (-). . . . . . . . . . . . . . White / Black
Right Rear (+) . . . . . . . . . . . . Violet
Right Rear (-) . . . . . . . . . . . . . Violet / Black
Left Rear (+) . . . . . . . . . . . . . Green
Left Rear (-) . . . . . . . . . . . . . . Green / Black
*NOTE: When Black wire is not present, ground radio to vehicle chassis.
All colors may not be present on all leads due to manufacturer's
specifications.
4
REV. 04/13/06
INSTALLATION
INSTRUCTIONS
Ford Premium Sound System Harness
To Integrate Aftermarket Radio
with Factory Amplifiers and Speakers
70-5511
Amplifier
Integration
Plug
TOOLS REQUIRED FOR INSTALLATION
• Cutting Tool • Tape • Crimping Tool • Connectors
1-800-221-0932
INST70-5511
©Copyright 2004 Metra Electronics Corporation
70-5511
70-5512*
KIT COMPONENTS
70-5512 *
Amplifier
Power
Harness
Integration
Plug
*Requires 70-1704
power harness
www.metraonline.com
Advertisement
Related Manuals for Metra Electronics 70-5511
Summary of Contents for Metra Electronics 70-5511
- Page 1 Factory Amplifiers and Speakers KIT COMPONENTS 70-5511 70-5512 * Amplifier Power Harness Integration Plug Amplifier Integration Plug *Requires 70-1704 power harness TOOLS REQUIRED FOR INSTALLATION • Cutting Tool • Tape • Crimping Tool • Connectors 1-800-221-0932 www.metraonline.com ©Copyright 2004 Metra Electronics Corporation...
- Page 2 TO INSTALL AN AFTERMARKET RADIO WHILE KEEPING THE FACTORY AMPLIFIER AND SPEAKERS Disconnect the negative battery terminal to prevent an accidental short circuit. Unplug the power and output connectors from the factory radio. (Figure A) Splice the wire from the aftermarket radio to the power and amplifier integra- tion harnesses using the color code on page 4 and the instructions included with...