Meridian 565 Installation Manual page 51

If the configuration you want is not catered for by one of the
standard settings, you can configure each source individually.
For each source you can configure:
The label used for it on the front panel display, from 54
alternative labels.
The audio input it selects.
The DSP preset to be used.
The comms type and address, to identify other Meridian 500
Series equipment.
The procedure for doing this is as follows.
To configure a source
Switch off the 565, using the power switch on the back panel.
Switch on the power again while holding down the Display
key on the front panel.
The display will show:
For example, to configure the CD
source the display initially shows:
The right-hand part of the display shows the current value of the
option.
To change an option
When you have finished programming sources:
Config
Press Source until the left-hand pair of characters identifies
the source you want to configure.
Press A or V to step between the alternative values for the
option.
Switch off at the back panel, and then switch on again to
restore normal operation.
C D C D
47