Meridian 565 Installation Manual page 39

To start the calibration procedure
Put the 565 into standby by pressing the Off key.
Press and hold the front panel Off key for at least five
seconds.
The display shows:
After a few seconds the display
shows:
followed by:
Levels is the name of the first calibration test. For more detailed
information about this and the other calibration tests see the
following sections.
To exit from the calibration procedure
You can exit from the calibration procedure at any time, and any
parameters you have set will be retained.
Calibration
To move between the calibration tests
Levels
The calibration tests are described in the following sections.
L e f t + 0 d B
Press Off on the front panel or Meridian System Remote.
Press Store on the front panel or Meridian System Remote.
35