Specifying Information About Your System - Meridian 562V.2 User Manual

Specifying information about your system

You can configure the operation of the 562V Multimedia
Controller to suit the way your system is set up, and the way in
which you want to use it. For more information about these
options see Changing the setup options, page 44.
These settings are configured automatically to appropriate
values when you choose one of the standard Type settings, and
you should not normally need to alter them; see Choosing
standard settings, page 28.
To configure the multimedia controller
Turn off the multimedia controller, using the power switch on
the back panel.
Turn on the power again while holding down the Display key
on the front panel.
The display will show:
It will then show the first
configuration option:
Press Display to move between the options.
Press A or V to change the value of the current option.
The table below shows the options you can configure.
Option
Communications mode (500 or 200)
Controller mode (Auto, Con, or NCon)
System address (1–8)
Product address (1–8)
DAC mode (NDAC or DACT)
Conf
Volume mode (VolM, VolS, or VolN)
5OO
Video version (562 or 562V)
200 Series CD player (N or Y)
Initial Value
5OO
Auto
SA=1
PA=1
DACT
VolM
562V
CD?N
33