Table of Contents
Advertisement
AC ADAPTER CONNECTION
Connect the AC adapter (included) to an AC outlet having 120V, 60Hz AC only.
Plug the small end into the DC jack on the rear of the unit.
CAUTION: Do not touch the AC adapter with wet hands. Fully insert the plug
without exposing any part of the blade.
DC 6V
Z
INSERTING BATTERIES
Two (2) "AAA" size batteries can also be used to power and/or to provide a backup
for the clock and alarm time for this unit as follows:
1. Open the battery door by pushing in on the tabs, then removing the door.
2. Insert two (2) "AAA" batteries as shown. Alkaline batteries are recommended
for the longest playing time.
3. Place the battery door back on the compartment.
NOTE: The batteries are used to back-up the clock, alarm time and radio preset
memories when the AC adapter is disconnected or there is a power failure.
–
Follow these precautions when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the
battery compartment. Reversed batteries may cause damage to the device.
3. Do not mix different types of batteries together (e.g. Alkaline, Rechargeable and
Carbon-zinc) or old batteries with fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to
prevent damage or injury from possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and
rupture. (Follow battery manufacturer's directions.)
BACKLIGHT
If the power supply is connected to the DC 6V IN jack, the backlight will always
light on in the display.
INSTALLATION
+
–
BATTERY PRECAUTIONS
6
+
Hide quick links:
Advertisement
Table of Contents
