Asus P5KPL-AM SE User Manual page 20

2. IDE connector (40-1 pin PRI_IDE)
The onboard IDE connector is for the Ultra DMA 100/66/33 signal cable. There are
three connectors on each Ultra DMA 100/66/33 signal cable: blue, black, and gray.
Connect the blue connector to the motherboard's IDE connector, then select one of the
following modes to configure your device.
Single device
Two devices
• Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA
cable connector. This prevents incorrect insertion when you connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.
P5KPL-AM SE
P5KPL-AM SE IDE connector
3. USB connectors (10-1 pin USB56, USB78)
These connectors are for USB 2.0 ports. Connect the USB module cable to any of
these connectors, then install the module to a slot opening at the back of the system
chassis. These USB connectors comply with USB 2.0 specification that supports up to
480 Mbps connection speed.
P5KPL-AM SE
P5KPL-AM SE USB2.0 connectors
1-11
Driver Jumper setting
Cable-Selected or Master
Cable-Select
Master
Slave
PRI_IDE
NOTE:Orient the red markings
on the IDE ribbon cable to PIN 1.
USB78 USB56
PIN 1
Mode of device(s)
-
Master
Slave
Master
Slave
If any device jumper is set as
"Cable-Select," ensure that all other
device jumpers have the same
setting.
PIN 1
Cable connector
Black
Black
Gray
Black or gray
Never connect a 1394
cable to the USB
connectors. Doing so will
damage the motherboard!
The USB module cable
is purchased separately.
ASUS P5KPL-AM SE