Windshield Wipers And Washer - Mazda 2008 MX-5 Miata Owner's Manual

MX-5_8X49-EA-07F_Edition2 Page205
Monday, June 25 2007 11:19 AM
Windshield Wipers and
Washer
The ignition switch must be in the ON
position.
WARNING
Use only windshield washer fluid or
plain water in the reservoir:
Using radiator antifreeze as washer
fluid is dangerous. If sprayed on the
windshield, it will dirty the
windshield, affect your visibility, and
could result in an accident.
Do not use the washer without first
warming the windshield and never use
plain tap water:
Using windshield washer fluid
without anti-freeze protection in
freezing temperatures is dangerous.
The washer fluid could freeze on the
windshield and block your vision. You
could have an accident.
NOTE
Because heavy ice and snow can jam the wiper
blades, the wiper motor is protected from
motor breakdown, overheating and possible
fire by a circuit breaker. This mechanism will
automatically stop operation of the blades, but
only for about 5 minutes.
If this happens, turn off the wiper switch and
park off the right-of-way, and remove the snow
and ice.
After 5 minutes, turn on the switch and the
blades should operate normally. If they don't
resume functioning, consult an Authorized
Mazda Dealer as soon as possible. Drive to
the side of the road and park off the right-of-
way. Wait until the weather clears before trying
to drive with the wipers inoperative.
Form No.8X49-EA-07F
Black plate (205,1)
Switches and Controls
qWindshield Wipers
Turn the wipers on by pulling the lever
down.
Intermittent
INT
1 Low speed
High speed
2
For a single wiping cycle, push the lever
up to MIST.
MIST Mist
qWindshield Washer
Pull the lever toward you and hold it to
spray washer fluid.
NOTE
With the wiper lever in the OFF or INT
position, the wipers will operate continuously
until the lever is released.
Driving Your Mazda
OFF
Washer
5-57