Installation instructions ,
for your new
Before you begin—Read these instructions completely and carefully.
IMPORTANT—OBSERVE ALL GOVERNING CODES AND ORDINANCES.
Note to Installer—Be sure to leave these instructions with the Consumer.
Note to Consumer—Keep these instructions with your Owner's Manual for future reference.
Tools Needed
• 5/16" nut driver
• Pliers
• Phillips screwdriver
Parts Included In Bag with Sub-Base
Type A
Type B
10 required
2 required
Type D
4 nuts
2 mounting clips
for metal case
Chaseway
and cover
Type C
2 required
Type E
2 mounting clips
for molded case
RAK204U, RAK204D20,
RAK204D30, RAK204E15,
RAK204E20, RAK204E30,
RAK204D15P, RAK204D20P,
RAK204D30P
Sub-base
Important Notes
• This unit must be properly grounded.
• Read this instruction before installing the
sub-base to the molded or metal case.
• CAUTION: The sub-base must be assembled to
the case before securing the case in the wall.
• ELECTRICAL REQUIREMENTS:
1. Electrical wiring may enter the sub-base
through any of the knockout holes provided in
the sub-base bottom or rear.
2. Refer to the unit nameplate for branch circuit
requirements.
3. All wiring should be done in accordance with
the local electrical codes and regulations.
4. Not approved for aluminum wire application.
5. If electrical wiring is placed in or against
the sub-base enclosure, the sub-base must
be grounded. Grounding holes have been
provided in the back surface of the enclosure.
See diagram. Green grounding screws and
securing nuts are included.
Kit Number
RAK204U
NON-ELECTRICAL SUB-BASE
RAK204D20
230/208V
RAK204D30
230/208V
RAK204E15
265/277V
RAK204E20
265/277V
RAK204E30
265/277V
RAK204D15P
230/208V
RAK204D20P
230/208V
RAK204D30P
230/208V
RAK205CW
CHASEWAY
RAK4002
JUNCTION BOX
RAK4002A
JUNCTION BOX
RAK4002B
JUNCTION BOX
Pub No. 30-7774-4 08-10 GE
Description
15/20A
30A
15A
20A
30A
15A
20A
30A
(For use with RAK204U)