Page 1
GPF325 SERIES KITS 1/4" Custom Dishwasher Door Installation and Access Panel Kit Instructions GPF325A, Almond Trim Kit GPF325B, Black Trim Kit GPF325C, Bisque Trim Kit GPF325W, White Trim Kit 1 CUT 1/4" THICK CUSTOM Before you begin PANELS TO SIZE...
Page 2
2 RETIRE EL CONJUNTO DEL PANEL DE ACCESO INFERIOR Escutcheon Escutcheon • Remove the two screws below the access panel. Retain screws. • Loosen the two screws located between the Door Door door and the access panel. Do not attempt Panel Panel to remove these screws.
Page 3
3 INSTALL DOOR PANEL TRIM AND CUSTOM PANEL (continued) • The notch on the side trim pieces goes • Slide custom door panel under the towards the front. Slide side trim up and “Z” trim and bottom trim. under the escutcheon and over the edge of the custom panel.
4 INSTALL CUSTOM INSTALLATION OPTIONS ACCESS PANEL This trim kit is designed to accommodate 1/4" thick panels. A raised panel screwed or • Place 1/4" custom panel in position on the glued to 1/4" thick backing can be used. access panel assembly. Use masking tape to The raised portion of the panel must be hold in position.
Page 5
JUEGOS DE LA SERIE GPF325 Juego de panel de acceso y puerta Instrucciones personalizado de 1/4 de pulg. (6 mm) del lavavajillas de instalación GPF325A, Juego de molduras almendra GPF325B, Juego de molduras negras GPF325C, Juego de molduras esmaltadas GPF325W, Juego de molduras blancas 1 CORTE LOS PANELES Antes de comenzar PERSONALIZADOS DE 1/4 DE...
Page 6
2 RETIRE EL CONJUNTO DEL PANEL DE ACCESO INFERIOR Lámina Escutcheon • Retire los dos tornillos que están debajo del panel de acceso. Conserve los tornillos. • Afloje los dos tornillos situados entre la Panel de puerta Door puerta y el panel de acceso. No trate de Panel retirar estos tornillos.
Page 7
3 INSTALE LAS MOLDURAS DEL PANEL DE PUERTA Y EL PANEL PERSONALIZADO (CONTINUACIÓN) • La ranura en las molduras laterales se • Deslice el panel de puerta debe orientar hacia el frente. Deslice la personalizado bajo la moldura en moldura lateral hacia arriba y debajo de “Z”...
4 INSTALE EL PANEL DE ACCESO OPCIONES DE INSTALACIÓN PERSONALIZADO Este juego de molduras se puede colocar en paneles de 1/4 de pulg. (6 mm) de espesor. • Ponga el panel personalizado de 1/4 de Se puede usar un panel sobresaliente pulg.