Motorcycle bluetooth camera and communication system (21 pages)
Summary of Contents for Kenwood XM50F
Page 1
Record the serial number, found on the back of the unit, in the spaces designated on the warranty card, and in the space provided below. Refer to the model and serial numbers whenever you call upon your KENWOOD dealer for information or service on the product.
Page 2
• Do not switch ON power until wiring is completed. KENWOOD XM50F and XM50R speakers will work best when powered by an amplifier. They have an imedance of 2 ohm and will cause damage if wired directly to the built-in radio power in ‘98-’05 factory...
Page 3
Gently pull the stock speaker out of each grille assembly. 3. Although the XM50F speakers will work behind the factory grille cloth, the metal mesh grilles in this kit are designed to replace the front speaker grille cloth on 1998-2013 HD Street Glides, Ultras, Classics, and Standards.
Page 4
Section 2 - XM50R Rear Speaker Installation Instructions 1. With your ignition switch in the “OFF” position, remove the factory speaker grilles by undoing the 4 screws on the front of the grilles. Carefully lift up each speaker and take the 2 wires off by pulling one at a time from the stock speaker.
Page 5
The following are not covered by the warranty: 1. Any product which is not distributed in the USA by KENWOOD or which is not purchased in the USA from an authorized KENWOOD dealer or an automobile dealer, unless the product is purchased through the U.S.A.